SVAT Electronics CVDVR200 - Manual (Page 8)

OPERATION
CONTINUED
REMARK
The event logging maximum can record 95 events for each hard disk, but the
screen can only show 7 events. If the events are more than 7 and the select
mark stays on the 7th event, press [ ] key once will roll up the next event till the
last event is shown. If the events are more than 95, the old recorded information
will be stored in HDD too. The user can playback it by button in search time.
To select playback by SEARCH TIME
1. Press button to skip the select mark [>] to select hard driver section, then
press the and button to move the ? cursor below the number back
and forth. Then, use the SELECT button to change the numeric values of
date & time.
2. Press the [ ] play button the system will play the recorded video from the
selected start time.
3. You may use the View button (during playback) to select which camera you
want to be displayed on the monitor. Full screen playback is available only
when the camera record selection is in Each mode.
4. To pause playback, press the
||
key.
5. During playback, if the user presses button, the system will skip 1200KB
video data and decode one frame; the system repeats the skipping and
decoding one frame till it meets the end of event recorded.
6. Fast forward function will work in FFx2, FFx4, FFx8 cycle. During playback, if
the user presses button, the playback mode will be played at FFx2
(2 times speed) and if the user presses one more time, the playback mode
will be played at FFx4 (4 times speed). If pressing one more time, the mode
will be played at FFx8 (8 times speed). Press the play button will return to
normal speed.
7. After playback operation, press key for other function operation.
CAUTION:
A jumper setting on the main board may be used to convert the operation for-
mat to PAL or NTSC to match the system of the display. The factory will preset as
the importer s request. However, if you find that your color TV screen can t show
color video, please check whether the jumper setting is matchable with the sys-
tem of your monitor or not.
MENU SETTING
MAIN MENU SETTING
Setting Operation Process
1. Press key to stop all functions in operation.
2. Press MENU key, the screen will display this menu.
3. In the main menu, the > indicator will be shown on the screen right next to
one of the ten different menu selections.
4. Press key or key to choose the function to be changed on the menu.
5. Press SELECT key to make changes in the selected option.
6. Press MENU key to exit menu setting.