Seiko Group POWERLITE 7500 UB - Manual (Page 38)

38
Making Detailed Adjustments
■ Progressive
Converts interlaced to progressive signals. The projector uses 3D DigiScan ™ HD
Circuitry Processing for video-sourced images. For film-sourced images, you can select
from 2-3 or 4-4 pulldown detection.
Leave the setting on Auto for viewing movies on a player that produces interlaced output.
Select Video for watching videos captured with a video camera. Set to Film if flickering
appears with the Auto setting.
Note: This setting can be used only when viewing composite video or S-video signals, or 480i
or 576i, or 1080i signals input through the Component, HDMI 1, or HDMI 2 ports (see page 67).
This setting cannot be changed while the 4-4 Pull-down setting is turned on (see page 39).
■ Noise Reduction
Note: This setting cannot be used when the Color Mode is set to x.v. Color (see page 29) or
with a signal input through the PC port.
This setting reduces flickering of analog images. You can select from 3 levels of noise
reduction.
■ Mosquito NR
Note: This setting cannot be used when the Color Mode is set to x.v. Color (see page 29) or
with a signal input through the PC port.
This setting reduces grainy noise that can appear around the edges of MPEG images. You
can select from 3 levels.
■ Block NR
Note: This setting cannot be used when the Color Mode is set to x.v. Color (see page 29) or
with a signal input through the PC port.
This setting reduces block noise that can appear when projecting MPEG images that have
been compressed at a low bit rate.
Signal > Progressive
Signal > Advanced > Noise Reduction
Signal > Advanced > Mosquito NR
Signal > Advanced > Block NR