Sony CLIE PEG-TJ35 - Manual (Page 137)

Using “Memory Stick™” media 137
Exchanging data via “Memory Stick” media
Note
When the battery power of your CLIÉ handheld is insufficient, data on “Memory Stick”
media will not be displayed. In this case, you need to charge your CLIÉ handheld or
connect the AC power adaptor with plug adaptor to your CLIÉ handheld.
Copying your CLIÉ handheld data to “Memory Stick” media
You can save your CLIÉ handheld data to “Memory Stick” media with CLIE
Files .
Notes
• Since copying data consumes a lot of power, you cannot use “Memory Stick” media
when your CLIÉ handheld battery power is low. In this case, connect your CLIÉ
handheld to the charger cradle.
• If your CLIÉ handheld receives IR communication while copying data, the copying
will be interrupted. Do not allow your CLIÉ handheld to receive IR communication
while copying data.
• Insert “Memory Stick” media into your CLIÉ handheld before copying or moving
data. Never remove “Memory Stick” media while you are copying or moving data
between your CLIÉ handheld and “Memory Stick” media.
• Incomplete copying or moving may leave an invalid file on your CLIÉ handheld or
the “Memory Stick” media. In this case, retry copying or moving, and if the confirm
overwrite message is displayed, tap [Yes] or [Yes to all].
1
Insert the “Memory Stick” media into your CLIÉ handheld.
2
Rotate the Jog Dial™ navigator to select (CLIE Files) on
the CLIE Launcher and press the Jog Dial™ navigator.
CLIE Files starts.
Tip
You can also tap (CLIE Files) to start CLIE Files .
Continued on next page
• • • • • • • • • • • • • • •