Sundance Spas 850 - Manual (Page 39)

Page 35
3. Reinstall jet internal by inserting it in any jet opening of the same jet
type. Rotate the jet internal clockwise with light pressure until your feel
the retaining mechanism “snap” in place. The jet’s nozzle should rotate
freely to the left or right using only fingertip pressure. If jet rotation
appears sluggish or obstructed at this time, repeat steps 2-3 until condi-
tion clears. If condition persists, contact dealer for technical support.
11.7 Maintaining The Cover
Using the Sundance insulating hot tub cover anytime the hot tub is not in use
will significantly reduce your operating costs, heat-up time and maintenance
requirements. To prolong the life of the cover, handle it with care and clean it
regularly using mild soap and water. Periodic treatments with a special con-
ditioner developed for Sundance hot tub covers will help protect against dete-
rioration caused by U.V. rays from the sun. Never allow anyone to stand or sit
on the cover, and avoid dragging it across rough surfaces.
11.8 Winterizing
Your Sundance hot tub is designed to automatically protect itself against freez-
ing when operating properly. During periods of severe freezing temperatures,
you should check periodically to be certain that the electrical supply to the
hot tub has not been interrupted. In extreme, bitter cold weather (less than
-20°F) reset the filter cycles for 24-hour operation to protect the hot tub (i.e.
four 6-hour cycles).
If you do not intend to use your hot tub, or if there is a prolonged power out-
age during periods of severe freezing temperatures, it is important that all
water be removed from the hot tub and equipment to protect against dam-
age from freezing.
For expert winterization of your hot tub, contact your authorized
Sundance Dealer. In emergency situations, damage can be minimized by
taking the following steps:
CAUTION: Turn off power to hot tub.
1. Follow the directions on page 32 for draining the hot tub.
2. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and into
the footwell.
3. When the water level ceases to drop, use whatever means available to
remove any remaining water from the footwell.
4. Turn the power to the hot tub back on briefly and press the AIR button