SIIG 2400 - Manual (Page 6)

6
Recharging your iPod and iPhone
When your iPod and iPhone is out of battery, you can
recharge it with the Portable Battery Charger-2400 easily.
Just make sure the Portable Battery Charger-2400 is fully
charged before proceeding.
1.
Connect the Apple USB 2.0 charging cable (supplied
with iPhone/iPod) to your iPod or iPhone
2. Connect the USB type A plug of the Apple USB 2.0
charging cable to the OUTPUT (USB port) of the
Portable Battery Charger-2400. See Figure 6 below.
3. During charging, all LEDs will not display to save
power.
4. During the charging process if the red LED of the
Portable Battery Charger-2400 starts flashing, this
signals that the battery power runs low. When this
happens, stop charging your iPod or iPhone and
recharge the Portable Battery Charger-2400 until it is
fully charged. Then repeat the above steps to
complete the device charging process.
Figure 6