Siemens WD7005 - Manual (Page 15)

13
First Wash Cycle
The installation of the washer-dryer is finished.
(See page 41-49)
Each washer-dryer has been tested in the factory.
A little bit of water can be left in the drum during the
test. Please carry out the first wash cycle without
laundry to remove any water left over from the
factory tests.
Do not use a special detergent for delicates or
wollens as these will create too much foam.
Pour half a measuring cup of detergent into
chamber II.
Input about 1 liter of water in chamber II.
Pull the detergent drawer out as far as it will go.
Turn the tape ON.
Turn the programme selector to 90 C Cottons/
coloureds.
,, , ,
Do not load any laundry.
Close the detergent drawer.
Close the washer-dryer door.
The programme ends when all symbols in the upper
row of the display field go out, the progress bar is
completely filled and the programme duration is on
,the buzzer sounds.
Press the Start button. The washing programme
starts.
,, , ,
Turn the programme selector to off position.