To insert ipod adaptor, Ipod playback, To remove ipod adaptor – Sony XL-DH229N User Manual

Page 5: To disconnect ipod, Navigating the ipod menus

Advertising
background image

09/9/8

XL-DH229N EN

E-4

9

8

7

6

5

4

3

2

1

Notes:

Once the iPod is connected to the unit it will begin
charging.

The iPod unit cannot be charged while the main unit is
in the stand-by mode or during USB mode.

Please make sure to set iPod unit to either NTSC or
PAL to match your TV signal. Please visit Apple’s
homepage for further information.

Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.

Note:

When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.

iPod operation:

The operations described below depend on the generation
iPod you are using.

System on operation:

When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function/exclude USB function).

System off (stand-by operation):

When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to stand-by mode.

Listening to the iPod (continued)

1

Open the iPod cover by pulling up the tip.

2

Insert the iPod adaptor into the iPod dock and connect
your iPod.

1

Press the ON/STAND-BY button to turn the power on.

2

Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.

3

Insert iPod unit in iPod dock of main unit.

4

Press the / button to start playback.

To insert iPod adaptor

pull up

iPod

Dock connector

iPod (bottom)

iPod dock

iPod connector

iPod adaptor
(not supplied)

iPod playback

Insert the tip of a screwdriver (“–”
type, small) into the iPod adaptor hole
as shown and lift upward to remove.

1

Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.

2

Use the TUNING (

or

) button on the remote

control to select an item on the menu and then press
ENTER button.

CD

USB

To remove iPod adaptor

To disconnect iPod

Navigating the iPod menus

Advertising