Sunbeam SNM1501RAX - Manual (Page 17)

17
Light
1. To replace light bulbs, first disconnect power to the oven at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light cover. (See illustration.)
3. DO NOT USE A BULB LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed in step 2.
CAUTION: Light cover may become very hot. Do not touch glass when light is on.
Charcoal Filter
Charcoal filter is used for non-vented, re-circulated
installation. The filter should be changed every 6 to 12
months depending on use.
1. Disconnect power to the oven at the circuit breaker panel
or by unplugging.
2. Remove the louver mounting screw from the top center of
the louver and push down carefully on the tab at each end
of the louver to disengage it. (See illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place and replace the
screw remove in step 2.
Oven Light
Remove the louver per instructions 1~ 3 above and charcoal
filter, if used.
1. Open light cover located behind filter mounting by
carefully pulling up on the front edge.
2. DO NOT USE A BULB LARGER THAN 30 WATTS.
3. Replace the oven light cover by carefully pushing into
place. Replace the charcoal filter, if used. Push the louver
back into place and replace the louver mounting screw.
Light cover Screw Light bulbs
Hood Louver
Oven light
Screw
Charcoal filter