Star Trac Spinner - Manual (Page 4)

Page 4 STAR TRAC GROUP CYCLES OWNER’S GUIDE
A
SSEMBLY AND
S
ETUP
_
A
SSEMBLY AND
S
ETUP
V-BIKE
®
SPINNER
®
ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your
STAR TRAC V-BIKE SPINNER.
U
NPACKING
Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the carton and fold back all four
flaps. Carefully tilt the box forward so that the box may be lifted to expose the cycle. Remove all parts from the shipping carton
and foam inserts, and verify that the following parts are included in your shipment:
Assembly Parts Spare Parts Kit
V-bike Parts List
Description Qty.
Description Qty.
Main Frame Assembly (not shown) 1 I. Tension Handles w/Washers 2
A. Handlebar 1 J. Tension Handles w/o Washers 2
B. Seat 1 K. Water Bottle Brackets 2
C. Handlebar Post 1 L. 8mm x 70mm (long) w/Washer and Nuts 2
D. Seat Post 1 M. 8mm x 60mm (short) w/o Washer and Nuts 2
E. Back Leg 1 N. Allen Wrenches, Metric 2
F. Front Leg 1 O. Multi-Purpose Wrench 1
G. Leveling Adjusters (pre-installed) 4
H. Pedals (set of two) 1
P. Spare Parts Kit (includes saddle, brake pad, bottom
bracket assembly, tension handle, pedal straps)
1
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the future.
Take time now to enter your V-bike ® Spinner ® serial number in the space below (serial number is located on the bottom cross
member). If parts are missing, or if you have any operational questions, please call Star Trac’s Service department at (800) 503-
1221; have your serial number ready.
Serial No._____________________________________________