Stanton Professional performance mixer SK SIX - Manual (Page 4)

back from the line output of the outboard unit. This creates the effects loop.
22. Power switch: Selects power "ON" or "OFF".
23. Power supply connector: Input connection for the accompanying power supply.
24. Master output: TRS balanced 1/4” master outputs.
25. Outputs: Record out and unbalanced master RCA.
26. Inputs: Line and phono signal inputs for channels 1 and 2. See note below.
27. Microphone input: 1/4” connector
28. Ground connectors: Connect to the turntables’ground connectors to eliminate electri-
cal hum. Ground connectors are usually supplied with turntables.
Note on audio signal inputs/outputs: Line inputs are used to connect to line level
sources such as CD players, samplers, tape players, etc. Phono inputs are
used to connect to turntables. Master output connects to an amplifier, EQ,
crossover, or other outboard signal processing. Record out connects to tape
recorder, mini disk recorder, etc.
TE C H N I C A L S P E C I FI C AT I O N S
Line inputs: 2 (RCA), 150 mV / 27K ohm
Phono inputs: 2 (RCA), 3 mV / 47K ohm
Semd: 2 (1/4”), 150 mV / 27K ohm
Return: 2 (1/4”), 775 mV / 1K ohm
DJ mic input: 1 (1/4 inch), 1.5 mV / 3K ohm
Master output: 1 (1/4” TRS Balanced/RCA unbalanced),
1.2 V / 100 ohm
Record output: 1 (RCA), 245 mV / 100 ohm
Headphone output: 1 (1/4 inch), 32 - 200 ohms recommended
Crossfader type: VCA
Frequency Response: 20 Hz - 20 kHz, +/- 2 dB
Tone Control : + 9/-26 dB (Hi, Low)
Gain Control: 20dB / 1 Khz
S/N Ratio: Less than 70dB
T.H.D: less than 0.2%
Dimension(LxWxD): 12 3/8 ” x 10 1/4 ” x 4” ( 314 x 260 x 102 mm)
Weight: 7 lbs (3.2 Kg)
WA R R A N T Y
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of twelve
(12) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N TY TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N TY REGIST R ATION FORM FOUND AT
W W W. STA N TO N M AG N E TI CS . CO M
2821 Evans Street • Hollywood, FL 33020
F U N C TI O N S ( c o n t ’d )