Samsung SRG-151PT - Manual (Page 6)

5
1. Place all shelves, all kinds of vessels in their proper positions which have been removed for transportation.
2. Clean refrigerator and parts to remove dust incurred during shipping.
3. Set cold control knob at "COLD" position and let refrigerator operate for one hour. Freezer compartment should get slightly chilled
and motor should run smoothly with no noise but soft hum.
4. Store food after the temperature in the refrigerator gets sufficiently low. It takes a few hours after starting the refrigerator to
reach the proper temperature.
5. Your refrigerator is operated by a compressor which switchs "on and off" to maintain the intemal temperature. When the
compressor is new it requires running in for a period of up to 2 months.During this period it may operate a little noiser than normal.
This is quite normal and does not represent a fault.
CONTROL SETTINGS
The temperature control maintains the temperature in the refrigerator. Setting the control at COOL is the
warmest setting. Setting the control at COLDEST is the coldest setting. Set the control at COLD.
Allow 24 hours for the refrigerator to reach the COLD temperature. If you want a colder or warmer
temperature,move the dial one setting at a time. Moving the control to OFF stops cooling but does
not turn off the power to the refrigerator. Setting the control to one of the snowflake positions may cause
freezing the refrigerator depending on the room temperature.
How To Test Temperatures
Use the milk test. Place a container of milk on a shelf and check it a day later. If the milk is too warm
or too cold, adjust the temperature control.
After changing the control, allow 24 hours for the refrigerator to reach the temperature you have set.
OFF
COLD
COOL
COLDEST
All of the following should be satisifed when tested in the followingorder, check electricity supply.
When the cause of trouble can not be located, contact your dealer.
INITIAL USING METHOD