Skil 2364 - Manual (Page 9)

INSERTING AND REMOVING
ACCESSORIES
Move reverse switch lever to the center “OFF”
position. Rotate the clutch ring to the drill bit
symbol“ ”. Rotate the chuck sleeve
counter-clockwise viewing from chuck end,
and open chuck to approximate drill bit
diameter. Insert a clean bit up to the drill bit
flutes for small bits, or as far as it will go for
large bits. Close chuck by rotating the chuck
sleeve clockwise and securely tighten by hand
(Fig. 2).
Do not use the power of the
drill while grasping chuck
to loosen or tighten bit. Friction burn or hand
injury is possible if attempting to grasp the
spinning chuck.
-9-
Assembly
! WARNING
Operating Instructions
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
“OFF” position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 1). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an “OFF” position.
FORWARD/REVERSE INDICATOR LIGHTS
Your tool is equipped with lights which
indicate the rotation of the bit.
For forward rotation, (with bit pointed
away from you) move the lever to the far left
and a green indicator light depicting a forward
arrow will light up.
For reverse rotation move the lever to the
far right and the green indicator light depicting
a reverse arrow will light up.
To stop in either direction just release the trigger.
To activate trigger lock move lever to the center
off position (Fig. 1).
ADJUSTABLE CLUTCH
Your tool features 8 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 7. The drill “ ” position
will lock up the clutch to permit drilling and
driving heavy duty work, and also enables bits
to be changed quickly and easily in the keyless
chuck (Fig. 1).
BRAKE
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, Hi-torque and High-speed. Hi-torque
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High-speed provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the Hi-torque or High-speed position.
FUEL GAUGE
Your tool is equipped with a fuel gauge that
alerts you when the battery capacity is getting
low. When the battery capacity reaches 30%
or less a red LED illuminates indicating the
battery will require charging (Fig. 3).
! WARNING
CHUCK
SLEEVE
FIG. 2
FIG. 3
FUEL
GAUGE
LED
BM 1619X03886 07-09:BM 1619X03886 07-09 7/23/09 10:54 AM Page 9