Swisher Truck Spreader 11730 - Manual (Page 3)

Item # Part # Description
1 10113 Deflector - Spreader
2 NB505 Bolt - 5/16-18 X 1 1/2 HCC GR5 ZY
3 NB556 Washer - USS Flat, 5/16 ZY
4 NB579 Washer - Fender, 5/16 X 1 1/4 OD ZY
5 7825Z Bushing - Lift Bar
6 10051 Spring - Gate, 12V ATV Spreader
7 NB555 Washer - USS Flat, 1/2 ZY
8 10112TK Gate - Hopper
9 10111TK Bracket - Motor Support, Upper
10 NB181 Nut - Nyloc 5/16-18 ZY
18 10192 Washer - Nylon Retainer 5/16"
20 10975 Tank - Truck Spreader
Step 1:
Assemble the components as shown.
Use the Nylon Retainer Washer (18)
to hold the parts together.
Step 2:
Attach the assembly
made in Step 1 to the
tank (20) by sliding the
bolts (2) up through the
tank and placing a
fender washer (4) over
each bolt. Thread a nut
(10) over each bolt and
tighten securely.
NOTE: To change the amount of material being spread,
adjust the hopper gate by pulling on the handle
until the desired flow is attained. A scale of one
to four has been provided with one being the
least amount, and four being the most. Zero
will seal the material from being distributed.