3. removing the paper – Star Micronics SP2000 Series User Manual
Page 26
Advertising
– 23 –
ENGLISH
6-3. Removing the Paper
Remove the cover, then cut off the paper near the rear of the paper guide and press
the FEED switch to feed out the paper remaining in the unit.
When the paper runs out, the POWER lamp will blink.
Note: 1. Remove the paper remaining in the printer by pressing the FEED
switch.
2. When the paper end mark appears on the paper, replace the roll
paper before it runs out.
[When the rewinder is used]
Remove the reel together with the paper rolled up on it.
Fig. 6-24
Paper
Reel
Spool
Advertising