SMC Networks SMC8013WG - Manual (Page 31)

Command ARP: "arp <[ether|cable]> <IP>"
Description: If there is no parameter specified for the ARP command, CM would display the
current sys ARP table. Otherwise, users must input the interface (ether or cable) and IP, and
then CM would send out an ARP request to ask the MAC address of the specified IP in the
correct interface.
Command ROUTERNAME: "routeName [name_of_router]"
Description: If users specify the command without parameter, CM would show the device
name. Otherwise, it will set the specified name as the device name.