Sony 4-269-996-E5(1) - Manual (Page 15)

15 GB
Getti
ng Sta
rt
e
d
– Or you can use DiSEqC command A
(1st satellite) and B (2nd satellite), if
your LNB or multi switch can handle
these commands.
– For four satellite channels, DiSEqC
control A, B, C, and D is required.
“LNB Low Band Frequency” and
“LNB High Band Frequency”:
– Specifies LNB frequency bands. Be
sure to check your LNB
documentation to set frequencies
(normally appears as “L.O.
frequency”).
– The default values are for a universal
LNB.
– If your LNB can handle both bands
(low and high), you can specify both.
If it handles only one, specify low
band.
“22 kHz Tone”: If your LNB is dual
band (low and high bands), set to “Auto”.
The TV will take care of everything
automatically; otherwise, set to “Off”.
“LNB Voltage”: Specifies the set
voltage for a dual polarisation LNB.
– 13/18V: default.
– 14/19V: if LNB cable is over 60m
long.
– Off: if an external power supply can be
used.
3 “Transponder” (for each satellite
setting- Satellite 1 to 4):
There is no need to set the transponder
when you select “Full Scan”.
“Scan for new services”:
– Tunes to a single transponder.
– This is an incremental scan, and it
should be used in cases when a new
transponder is added to a satellite.
– Previously-tuned programmes are kept
and found ones are added to the
program list of the satellite connection
you are editing.
1
Press HOME, then select > “Digital
Set-up” > “Satellite Auto Tuning”.
2
Follow the instruction on the Satellite
Auto Tuning.
~
• “Scan for new services” is unavailable while
performing the initial set-up.
• When you scan for the new services, please
check if the satellite signal is available.
Digital Auto Tuning: When you select
“Cable”, we recommend that you select
“Quick Scan” for quick tuning. Set
“Frequency” and “Network ID” according
to the information supplied from your cable
provider. If no channel is found using
“Quick Scan”, try “Full Scan” (though it
may take some time).
~
• “Full Scan” may not be available depending
on your region/country.
Programme Sorting: Changes the order of
analogue channels stored in the TV.
1
Press F/f to select the channel you want
to move to a new position, then press .
2
Press F/f to select the new position for
the channel, then press .
~
• For satellite channels, select “Satellite
Programme Sorting” in “Digital Set-up” of
“Settings” to change the order of satellite
channels in the same procedure above after
initial set-up completed.
• You can also tune channels manually.