Standard Horizon Ff520 - Manual (Page 21)

FF520 Page 23
The R
ANGE
Soft Key
By pressing [R
ANGE
] the window switches to the next RANGE status: MANUAL, BOTTOM
LOCK and AUTO.
If MANUAL is selected move the ShuttlePoint knob up or down will adjust the depth value
in 10 Ft steps. To adjust the Shift move the ShuttlePoint knob to the Left or Right.
When BOTTOM LOCK is selected, move the ShuttlePoint knob up or down to adjust the
Bottom range 10 Ft at a time.
If AUTO RANGE, the range value is set automatically by the FF520 and it cannot be
changed by the user.
The F
REQUENCY
Soft Key
Pressing the [FREQUENCY] Soft Key toggles the FF520 output frequency between 50,
200kHz and Auto. The current value or Frequency is shown on a window right over the
[F
REQUENCY
] label. [F
REQUENCY
] is not shown when the Fish Finder shows 50 and 200kHz
Dual page.
The Sensitivity Time Control (STC) Soft Key
[STC] changes the STC value between OFF/SHORT/MID/LONG/CUSTOM. The current
value of STC is shown on a window right over the [STC] label. Move the ShuttlePoint knob
left or right will adjust the value.
3.3 SYSTEM INFORMATION PAGE FOR CP155C/CP175C/CP1000C
For troubleshooting you maybe asked by a Standard Horizon Product Support Technician
for the software version of Fish Finder.
The following procedure is how to access this information.
1. From the Chart Page, press [MENU] to open the Main Menu.
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENTER] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information on the Fish Finder Library version
and on the Fish Finder module type and version.
4. Press [CLEAR] to exit.
3.3.0 The System Update menu
The System Update menu allows downloading the Fish Finder firmware into the Fish Finder
device. To select this menu follow the procedure:
1. From the Chart Page, press [MENU] to open the Main Menu.
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENTER] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information.
4. Press [MENU].
5. Move the ShuttlePoint knob to highlight BBFF FIRMWARE SOFTWARE and press
[ENTER] or move the ShuttlePoint knob to the right.
6. The current Fish Finder firmware version is shown in the System Update window that
appears on the screen. Insert the C-CARD with the firmware in one of the GPS Chart
Plotter available slots, and the press [ENTER] to update.