Assembling unit batteries, Proper use of the arm cuff – Sunbeam HEALTH AT HOME 7623 User Manual

Page 3

Advertising
background image

ASSEMBLING

UNIT

Batteries

install batteries remove the battery cover and insert the batteries into the

battery compartment as shown. Use only “AA” alkaline batteries.
A. Remove the battery cover from bottom of unit. Insert four

size alkaline

batteries as shown, taking care to observe the proper direction for each battery.

Use of alkaline batteries is recommended.

B. Replace battery cover.

Push the air connector firmly into the air socket on the back of the unit.

Important Notes

l

Replace all four batteries if the low battery symbol appears on the display.

l

Remove batteries if storing the unit more than six months without use. Never

leave dead batteries in an unit since they may leak and cause damage.
Memory data will be cleared when batteries are changed or become exhausted.

Proper Use of the Arm Cuff

Please relax and remain seated or reclined in a quiet location for 5 to 10

minutes prior to taking a measurement.

Remove any clothing on the upper arm so that the cuff can be placed directly on

the skin. Constriction of the upper arm caused by rolling up a shirt sleeve may

cause an inaccurate reading. Avoid this condition by completely removing the

garment causing the constriction.

Wrap the cuff around the upper arm as shown in the diagram on page 3. The

lower edge of the cuff (edge with air hose attached) should be about 1 inch

above the elbow. Position the cuff so that the hose runs along the inside of

the left arm.

P a g e 2

Advertising