Sherwood RX-4109 - Manual (Page 15)

14
Listening to FM stereo broadcasts
• Then “PRESET” lights up.
• While listening to FM broadcasts, press the FM
MODE button.
• Each time this button is pressed,
the FM mode changes as follows:
Stereo mode : “ST” lights up.
Mono mode : “ST” goes off.
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode
to reduce the noise, then FM broadcasts are
reproduced in monaural sound.
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence.
• At the desired station, press this button again to
stop scanning.
• When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will
be tuned to automatically without selecting the
preset mode.
Tuning to preset stations
1
.
After selecting the tuner as an input source, select the preset mode.
2
.
Select the desired preset number.