Sony CMT-HX5BT - Manual (Page 32)

CMT-HX5BT.GB.3-095-518-61(1)
 GB
To improve tuner reception
Turn off CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION  repeatedly to
select the CD function, and then turn
off the system.
2
After “STANDBY” stops flashing, press
/  on the unit while holding
down /CANCEL  on the unit.
“CD POWER OFF” appears. With CD
player power turned off, disc access
time is increased. To turn on CD
player power, repeat the procedure
until “CD POWER ON” appears.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press /CANCEL  , DSGX  and
/  at the same time.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.
Messages
CD/MP3 player, Tuner
Complete!: The preset operation ended
normally.
Invalid: You pressed an invalid button.
LOCKED: The disc tray does not open.
Contact your nearest Sony dealer.
No Disc: There is no disc in the system,
or you have loaded a disc that cannot
be played.
No Step: All of the programmed tracks
or files have been erased.
Over: You have reached the end of the
disc while pressing   during
playback or pause.
Push SELECT!: You tried to set the clock
or timer during timer operation.
Push STOP!: You pressed PLAY MODE
 during playback.
Reading: The system is reading
information of the disc. Some buttons
are not available.
SET CLOCK!: You tried to select the timer
when the clock is not set.
SET TIMER!: You tried to select the timer
when the Play Timer is not set.
Step Full!: You tried to program more
than 26 tracks or files (steps).
TIME NG!: The Play Timer start and end
times are set to the same time.
Bluetooth device
Connect: Bluetooth communication was
established.
Disconnect: Communication with a
Bluetooth device was cut off for some
reason, or Bluetooth communication
was ended.
No Device: A pairable Bluetooth device
was not found, or connection was not
possible.
Not in Use: The system is not connected
with a Bluetooth device using AVRCP.