Samsung SP-C700R - Manual (Page 19)

36 35
● Press button to reduce
the noise.
(Refer to page 31)
● Check if the distance is too far
from the base set.
(Refer to page 31)
● Try installing the base set at
a different location.
● Check if the base set is currently
in use. Try again after the call in
the base set has been hung up.
● Check to see if you are too far
away from the base set. If yes,
move closer toward the base set.
(Refer to page 31)
● If you see the mark on
the screen, hang up the phone
and adequately charge your
remote set.
(Refer to page 31)
I hear many noises while
using the remote set.
I hear beeping warning
sounds in the remote set.
;;
;;
;;
@@
@@
@@
The phone does
not work at all.
I cannot hear the tone
when I press button.
The phone does not ring in the
base set or the remote set.
Internal or transferring
calls are not working.
The morning call/alarm
does not work.
● Is the phone correctly installed?
(Refer to page 9)
● Is the power correctly connected
to the appropriate voltage?
(Refer to page 9)
● Check if the batteries are
correctly inserted to the remote
set. (Refer to page 10)
● Check if the batteries are
adequately charged.
(Refer to page 10)
● Check if the power is on.
(Refer to page 9)
● Check if the phone is correctly
connected.
(Refer to page 9)
● Check if the power is correctly
connected.
(Refer to page 9)
● Check if the batteries are
correctly inserted.
(Refer to page 10)
● Check if the batteries are
adequately charged.
(Refer to page 10)
● Check if the power of the remote
set is on. (Refer to page 9)
● Try re-registering the remote set
to the base set.
(Refer to page 33)
● Check if the BELL OFF is
selected. (Refer to page 21)
● Check if you have installed the
phone correctly.
(Refer to page 9)
● Try re-registering the remote set
to the base set.
(Refer to page 33)
● Check if the current time is
accurately set.
(Refer to page 15)
● Check if the morning call
time is set.
(Refer to page 22)
● Check if the morning call/alarm
function is set.
(Refer to page 22)
● Check if the charging connector
is clean.
● If the charging connector is not
clean, use a cotton tip or an
eraser to wipe it clean.
(Refer to page 37)
● Check if the power voltage is
appropriate. (Refer to page 9)
● If you have cleaned the charging
connector but it still does not
work, then please contact your
local service center and
purchase new batteries.
(Refer to page 10)
I cannot recharge
the remote set.
Troubleshooting
Reference
● When there is a problem with radio communication between
the base set and the remote set, do the following, and if it
still will not work, then please contact your local Samsung
Electronics Service Center.
● Follow instructions in the order.
※ See page 33 for registering a remote set
� � � �
� � � �
Base
Set
Remote
Set