Samsung CLX-318X - Manual (Page 41)

Network setup (CLX-3185N/CLX-3185WK/CLX-3185FN/CLX-3185FW only)_ 1
1.
network setup
(clx-3185n/clx-3185wk/clx-3185fn/clx-3185f
w only)
This chapter gives you step-by-step instructions for setting up the network connected machine and software.
This chapter includes:
• Network environment
• Introducing useful network programs
• Using a wired network
• Installing wired network-connected machine’s driver
• IPv6 Configuration
Supported optional devices and features may differ according to your
model. Check your model name.
(See "Features by Models" on page 2).
Network environment
You need to set up the network protocols on the machine to use it as your
network machine. You can set up the basic network settings through the
machine's control panel.
The following table shows the network environments supported by the
machine.
Introducing useful network programs
There are several programs available to setup the network settings easily in
network environment. For the network administrator especially, managing
several machines on the network is possible.
Before using the programs below, set the IP address first.
SyncThru™ Web Service
Web server embedded on your network machine, which allows you to do
the following tasks.
• You can configure the network parameters necessary for the machine to
connect to various network environments.
• You can customize machine settings.
(See "Using SyncThru™ Web Service
(CLX-3185N/CLX-3185WK/CLX-3185FN/CLX-3185FW only)" on
page 1).
SyncThru™ Web Admin Service
Web-based machine management solution for network administrators.
SyncThru™ Web Admin Service provides you with an efficient way of
managing network devices and lets you remotely monitor and troubleshoot
network machines from any site with corporate internet access. Download
this program from http://solution.samsungprinter.com.
SetIP
This utility program allows you to select a network interface and manually
configure the IP addresses for use with the TCP/IP protocol.
• See "IPv4 setting using SetIP Program (Windows)" on page 2.
• See "IPv4 setting using SetIP Program (Macintosh)" on page 3.
• See "IPv4 setting using SetIP Program (Linux)" on page 3.
TCP/IPv6 is not supported by this program.
Using a wired network
You must set up the network protocols on your machine to use it on your
network. This chapter will show you how this is easily accomplished.
Item Requirements
Network interface • Ethernet 10/100 Base-TX
• 802.11b/n/g Wireless LAN
(CLX-3185WK and CLX-3185FW only)
Network operating system • Windows 2000/Server 2003 /Server
2008/XP/Vista/7/Server 2008 R2
• Various Linux OS
• Mac OS X 10.3 ~ 10.6
Network protocols • TCP/IPv4
• DHCP, BOOTP
• DNS, WINS, Bonjour, SLP, UPnP
• Standard TCP/IP Printing (RAW), LPR,
IPP, WSD
• SNMPv 1/2/3, HTTP (S), IPSec
• TCP/IPv6 (DHCP, DNS, RAW, LPR,
SNMPv 1/2/3, HTTP (S), IPSec)
(See "IPv6 Configuration" on page 6)
Wireless security • Authentication: Open System, Shared
Key, WPA Personal, WPA2 Personal
(PSK)
• Encryption: WEP64, WEP128, TKIP,
AES