Soundstream Technologies 300SX - Manual (Page 3)

l l
1 2 3
0 0
1.
2.
3.
4.
5.
6.
7.
9.
Kev to Caiiouts
Fault LED Indicates a blown fuse.
High Power LED Indicates amplifier power on in “High Power’
mode.
High Current LED Indicates amplifier power on in “High Current”
mode.
Connect to a fuse or circuit breaker, then to the batfery’s
positive post.
GND Main ground connection. to a clean chassis ground in
the vehicle.
REM Remote turn-on input from the head unit. Accepts
Speaker Output Connections Left and right channels.
Input Level independent Left and Right channel input level
controls.
Inputs Right and left channel RCA (Differential Balanced inputs;
only right channel input is used in “Mono” mode.
IO. Main Fuse-Main power supply fuse. only same
value fuse.
11. Crossover -Crossover frequency settings for the amplifier.
See page 9 for more details.
12. Amplifier Crossover Select high pass, low pass or full range
amplifier operation.
13. Mixed Mono/Stereo/Bridge Select “Bridge” for bridged mono
operation (use right channel input). Select “Stereo” for coherent
stereo operation. Select “Mixed Mono’ for simultaneous stereo
bridged mono operation.
14. High Power High Current Switch Use HIGH CURRENT for
loads at or below ohm stereo (2 ohms mono). CAUTION: DO
NOT SWITCH WHEN AMPLIFIER IS TURNED ON.
5