Star Micronics RS 232C Serial to Parallel Converter SPC-8K - Manual (Page 3)

1
English
INTRODUCTION
The Serial to Parallel Converter is an EIA compatible serial device that can
interface, STAR Printers with nearly every Micro-Processor which requires
standard EIA (serial) interfacing.
Please read this manual completely before proceeding to “power-up”! This
will ensure successful operation of your Serial to Parallel Converter.
In addition to the converter, you will also need a proper serial cable.
Consult with the dealer where you bought your printer if you are unsure about
the type of serial cable you need for your system.
Serial Connector
Connect to the Serial
Cable.
Clear Button
Clears the internal
buffer when this button
is pressed.
Parallel Connector
Connect to the printer.
DIP Switch
Sets serial mode.
Refer to the following
section.