Sunbeam WF5700 - Manual (Page 5)

Using your Pure Source Water Filter System.
Before using your Sunbeam Pure Source Water
Filter System.
Carefully unpack the appliance and check that
all components listed are included.
Wash the water jug and lid with warm soapy
water then rinse thoroughly and dry.
Wipe the appliance over with a clean cloth or
paper towel.
Do not wipe the base with a used kitchen cloth,
because you could contaminate it with bacteria
Inserting the filter.
Remove the two red plugs from the new filter
tubes and make sure the black O-rings are
pushed into place on the tubes.
Place the appliance on a flat level surface with
the rear of the unit facing you.
With the two filter tubes at the top, insert the
filter into the cavity and push inward and
upward. The filter is firmly secured when you
hear a soft snap sound.
Plug the appliance into the electrical outlet and
turn the power on.
Push the reset switch to activate the Electronic
Safety Monitor.
Preparing to flush the filter.
Remove the water jug from the base and fill
with water. Place the full jug back on the base
so that it stands flat.
Place a large container or jug (at lease 2.75
litres) under the spout on the left side (just
above the grey manual water dispenser).
Flushing the filter .
The first couple of jugs of filtered water may
contain some black dust released from the
carbon filter. Although this is not harmful, we
recommend that you flush the filter twice and
discard both batches of filtered water.
Push the Auto-Flow button (Shown in Figure 2)
and the entire contents of the water jug will be
filtered and dispensed into the container placed
under the spout. The appliance will
automatically shut off when the jug is empty. It
is normal for a small amount of unfiltered water
to remain in the bottom of the water jug.
Note: During the flushing process, the appliance
may splutter as the air inside the filter is
replaced by water. You will notice a change in
the filtering noise when the water jug is almost
empty.
Filtering water.
For manual dispense, place a glass or jug under
the spout and push it against the manual water
dispenser button. To filter the entire contents of
the water jug, place a large container or jug (at
lease 2.75 litres) under the spout. Press the
Auto-Flow button. The appliance will
automatically shut off when the jug is empty.
Filter life.
The life of the filter is approximately 750 litres.
However, your filter may need replacing more
regularly, depending on frequency of use and
the quality of your tap water. If you notice that
the water begins to flow very slowly from the
spout it is time to change the filter.
The Electronic Safety Monitor light will begin to
flash approximately 30 litres before the filter
requires changing. When the filter requires
changing the appliance will automatically shut
off until the filter is replaced and the reset
button is pressed.
Figure 2