Snom 105 - Manual (Page 10)

10 • Installation
[
S N O M
1 0 5 U
S E R
M
A N U A L
V 2 . 0 2 ]
snom technology AG • 11
[
S N O M
1 0 5 U
S E R
M
A N U A L
V 2 . 0 2 ]
1
If you want to use an external power supply, use the one that is
included in the package. Other power supplies may cause damage to the
phone, affect the behavior or induce noise.
Setting up the Phone
The snom 105 should only be placed on even, horizontal surfaces that
enable the rubber pads to ensure a secure grip. Do not place the snom
105 on carpets or other materials that contain fibers that could block the
air vents and cause overheating.
Cleaning
To clean the snom 105 use an anti-static cloth. Please avoid cleaning
liquids as they might damage the surface or internal electronics of the
phone.
Connecting the phone
First connect one end of the handset cable to the handset and
then to the jack on the left-hand side of the phone (see illustration).
Next plug in the Ethernet (network) cable into the RJ45
connector, which is nearest to the edge on the rear side of the phone (as
shown below) and plug the other end into the network side to establish
a data link. The second RJ45 connector in the middle on the rear side of
the phone is for daisy chaining further Ethernet devices without needing
a second Ethernet connection line.
If you are using an external power supply, please insert the plug
of the power supply into the connector next to the data line and hook up
the casing into the mains.
If you want to use a headset, it can be connected to the audio
jacks on the rear side of the snom 105. The outermost connector is for
the microphone.