Samsung Refrigerator - Manual (Page 19)

CAUTION
01
s
E
tting
u
P
setting up your side-by-side
refrigerator
Connecting the water line to the refrigerator
1. Remove the cap from water line on the unit and insert compression nut to the water line on the unit
after disassembling from provided water line.
2. Connect both water line from the unit and water line provided kit.
3. Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these places should be examined
• Samsung Warranty does not cover
WATER LINE INSTALLATION.
• It’ll be done at customer’s charge
except the retail price includes
installation cost.
• Please contact Plumber or Authorized
Installer for the installation if needed.
• If Water leakage happened due to improper installation, Please contact installer.
Remove
cap
Water Line
from unit
Water Line
from Kit
No gap
Loosen a
Installing the water filter.
1. Remove the water filter from the box and put a replacement
indicator sticker on the filter as shown.
2. Place a sticker on the filter that dates six months in the
future. For example, if you install the water filter in March,
put the “SEP” sticker on the filter to remind you to replace in
September. That way you’ll know when it is time to replace
the filter. Normally filter life is about 6 months.
3. Next, remove the fixed cap by turning it counter clockwise.
Keep the cap in a safe place for use if you choose not to use a
filter.
4. Remove the filter’s protective cap and then
position and insert the filter into the filter housing.
5. Slowly turn the water filter clockwise 90º to align
with the indication mark on the cover, locking the
filter in position. Make sure that the indicator is
lined up with the “lock” position. Remember, do
not over-tighten.
If your model contains wine shelf, you should
remove the wine shelf before installing water
filters.
setting up _1
sticker
(Month indication)


1
Cover filter
align the indication
mark with lock position
separation
of red cap
DA99-01583A(HM)-EN(0.0).indd 19 2007.8.23 4:25:40 PM