Sharp Notevision PG-F261X - Manual (Page 45)

43
Useful
Features
Adjusting the Projector Function (“PRJ - ADJ” Menu)
Auto Power Off
System Sound
System Lock
h
On
On
Auto Restart On
STANDBY Mode Standard
0 min 0 Lamp Timer(Life) 100%
Picture SCR - ADJ PRJ - ADJ Help
SEL./ADJ. ENTER END
Speaker On
Audio Input Audio 1
RS-232C 9600 bps
Fan Mode Normal
Disable
Menu operation n Page 37
• When the Auto Power Off function is set to
“On”, 5 minutes before the projector enters
standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes.
Selectable
items
On
Off
Description
When no input signal is detected for
more than 15 minutes, the projector will
automatically enter standby mode.
The Auto Power Off function will be
disabled.
Note
1 1 1 1 1 Auto Power Off Function
5 5 5 5 5 Speaker Setting
4 4 4 4 4 Setting the Confirmation
Sound (System Sound)
Selectable
items
On
Off
Description
A confirmation sound is made when
the projector turns on/off.
No confirmation sound is made.
When set to “Eco”, power consumption is
reduced in standby mode.
3 3 3 3 3 STANDBY Mode
Selectable
items
On
Off
Description
The audio signal is output from the
internal speaker.
The audio signal is not output from the
internal speaker.
6 6 6 6 6 Monitor Output
This function allows you to select an
appropriate combination of audio input
terminals for each input mode.
6 6 6 6 6 Audio Input
Selectable
items
Audio 1
Audio 2
Description
The AUDIO 1 input terminal is used as
an audio input terminal.
The AUDIO 2 input terminal is used as
an audio input terminal.
Selectable
items
Eco
Standard
Description
The monitor output and RS-232C functions
are switched off in standby mode.
The monitor output and RS-232C
functions are activated even if the
projector is in standby mode.
2 2 2 2 2 Auto Restart Function
Selectable
items
On
Off
Description
If the power cord is unplugged from the
outlet or the breaker switch is turned off
when the projector is on, then the
projector automatically turns on when
the power cord is plugged into the AC
outlet or the breaker switch is turned on.
The projector does not turn on
automatically when the power cord is
plugged into the AC outlet or the
breaker switch is turned on.