Star Micronics SP200F SERIES - Manual (Page 13)

– 10 –
ENGLISH
4 Place the ribbon cartridge in the
direction shown in Fig. 4-10 and
press it down to load it. If loading
of the ribbon cartridge is not sat-
isfactory, press down the car-
tridge while rotating the ribbon
feed knob in the direction of the
arrow.
5 Turn the ribbon feed knob of the
ribbon cartridge in the direction
of the arrow to remove slack in
the ribbon.
6 Close the Auto Cutter.
7 Mount the cover by reversing the
procedure outlined in step 2
above.
Note: When removing the rib-
bon cartridge, raise the A
section and then remove
it by holding the B section
as shown in Fig. 4-11.
Fig. 4-10 Loading the ribbon cartridge
Print head
Ink ribbon
Auto cutter
Ribbon cartridge
Ribbon feed
knob
Notched
part
A
B
Fig. 4-11