SATO GT424 - Manual (Page 29)

Section 2: Installation
GT Series Operator’s Manual Page 2-17
2.3 LOADING LABELS AND TAGS (CONT’D)
2.3.2 Loading Fanfold Paper
1. Lift up the main cover. Make sure that the cover rests
firmly on the top of the printer so that it will not fall
forward and injure your hands.
2. Remove the release screw that holds the rear cover in
place. Keep the screw in a safe place for easy
retrieval later.
3. Tilt the rear cover until it rests on the table surface.
On the surface of the cover you will see a factory-
imprinted line that guides you in aligning the fanfold
paper so that it feeds at the correct angle into the
printer.
4. Load fanfold paper on top of the cover, up to 20 cm in
height. Align the stack of fanfold paper to the factory-
imprinted line.
5. Pass the paper from the tray over the Roll Paper
Feeder. Adjust the Roll Guide so that it is in contact
with the side of the paper. This will ensure that the
paper moves forward at a consistent angle. (To move
the Roll Guide forward or backward, first push the
purple lever at the top of the guide sideways.)
Front Cover
Rear cover
release screw
Rear cover
Rear cover
Roll Guide
Roll Paper
Feeder