SATO GT424 - Manual (Page 53)

Section 3: Configuration and Operation
GT Series Operator’s Manual Page 3-17
3.9 ADVANCED MODE
Advanced Mode lets you configure the more advanced features of the printer hardware.
3.9.1 Entering Advanced Mode
1. Press the LINE button to take the printer OFFLINE.
2. Pull down the cover of the Operation Panel and press
ENTER. The ONLINE MODE screen appears.
3. Press the arrow buttons until you see “ADVANCED
MODE”, then press ENTER to perform the first setting. At any time
in this mode, you can press the FUNCTION or CANCEL key to
return to the Advanced Mode screen.
3.9.2 Selecting The Print Density
This first setting in ADVANCED MODE lets you set how dark the
print quality is. Available options are from ‘A’ to ‘F’, with ‘F’ being
the darkest density. The default value is ‘A’.
Adjustment of this setting is usually unnecessary. To adjust the
print density, use the / buttons to select an option.
Press ENTER to confirm your selection and proceed to the next
setting.
3.9.3 Setting the Automatic Detection of Optional Units
The next setting, PRINTER TYPE AUTO SETTING, determines
whether the printer automatically detects the installation of optional
peripherals such as a peeler or cutter. If detected, an optional
peripheral will be used without needing further user configuration.
Use the / buttons to select either YES or NO. The default
option is YES (auto detect). Choose NO if optional devices are
installed, but you have wish to override the automatic settings.
Press ENTER to proceed to the next setting.