Sony MZ-R410 - Manual (Page 50)

50
model name1[MZ-R410/R410DPC] model name2[MZ------]
[3-247-012-11(2)]
masterpage:Left
filename[\\Ww001\WW001\ON GOING\MZ-R410 revision\-
11GB\3247012112\32470121112MZR410CED\02GB-MZR410CED\040OPE.fm]
The recorder does
not work or works
poorly. • While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Disconnect all the power sources.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• The disc is record-protected (“SAVED” appears).
, Slide the tab (page 61).
• Recording level is too small to record (when recording
manually).
, Pause the recorder and adjust the recording level.
• A premastered MD is inserted (“PbONLY” appears) when
recording.
, Insert a recordable MD.
• You tried to turn group mode on while setting the program.
, Turn group mode on before setting the program.
The recorder does
not start recording. • The recorder may be in recording standby mode (i.e., you
pressed X while pressing REC ).
, Press X to start recording.
The recorder
overwrites existing
materials when
record. • The record starting-position setting (“R-Posi”) is set to
“FrHere”.
, Set “R-Posi” setting to “Fr End”.
“No SIG” appears in
the display when
recording from a
portable CD player. • There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use the
AC power adaptor and disable the anti-skip function (such as
ESP) on the CD player (page 16).
There is no recording
on the MD after a
recording operation. • The AC power adaptor was unplugged or a power outage
occurred during recording.
The lid does not
open. • The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
• The lid is not firmly closed.
, Close the lid until it clicks. Then press OPEN to open the lid.
No sound comes
through the
headphones/
earphones. • The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to i.
• Volume is too low.
, Adjust the volume by pressing VOL +, –.
• The plug is dirty.
, Clean the plug.
Symptom Cause/Solution
040OPE.fm Page 50 Tuesday, October 29, 2002 3:09 PM