SECO-LARM USA ENFORCER EVT-SBP-GQ - Manual (Page 2)

ENFORCER VGA B
ALUN
ENFORCER VGA B
ALUN
Page 2 Page 3
Installation:
1. Make sure to use shielded twisted pair (STP) cable terminated with shielded RJ-45 connectors. This will ensure
good signal levels between the various video components.
2. Since Cat 5 does not have sufficient lines to support VGA handshaking and control signals, it will be necessary to
configure the monitor settings before installing the baluns:
To configure the monitor, connect it to the PC (or other video source), using a standard VGA cable. Configure the
monitor (resolution, color depth, refresh rate, and so on) to the desired settings. Also, set the contrast and
brightness levels to maximum. These will be adjusted after the VGA baluns are connected.
3. Turn off the power to the PC and monitor and disconnect the VGA cable.
4. Connect the PC side balun (EVT-TBP-GCNQ) to the VGA connector of the PC or video source.
5. Connect the monitor end balun (EVT-RBP-GNCQ) to the VGA display screen or video destination.
Note: For CRT monitors, a gender changer may be required. The CA-1D1DQ is designed to connect the
EVT-RBP-GNCQ to the CRT monitor cable.
6. Connect a shielded Cat 5 cable to the RJ-45 jacks on each of the baluns.
7. Make sure to tighten all the connections.
8. Turn on the PC and monitor.
9. Adjust the monitor contrast and brightness settings for comfortable viewing.
Figure 7:
Dimensions
Specifications:
Bandwidth DC to 60MHz
Impedance Input: RGB 75 (DB15 HD)
Output: RGB 100 (RJ-45 shielded)
Horizontal & vertical sync: TTL standard
Insertion loss Less than 3dB per pair over frequency range.
Video Signal Return loss Greater than -15dB over frequency range
Common mode rejection 15kHz -60dB max., 100kHz to 10MHz -40dB max.
(CMRR) 100MHz -20dB max.
Devices PCs, DVRs, DVD players, CRT/LCD/Plasma displays,
and projectors
Connectors RJ-45 shielded
DB15 HD male (to VGA output of PC), 6" lead
DB15 HD male (to VGA monitor input), 6" lead
Cable Cat 5 or better shielded twisted pair (STP) is recommended
Maximum Distance: VGA: 640x480, 450’ (137m)
Cat 5 shielded SVGA: 800x600, 350’ (107m)
twisted-pair cable XGA: 1024x768, 250’ (76m)
SXGA: 1280x1024, 200ft (61m)
RJ-45 Pin out
Operating Temperature 32 o ~131 o F (0 o ~55 o C)
Dimensions 2 1 /
8
" x 1 3 /
16
" x 1" (55 x 30 x 26 mm) with 6" (152mm) pigtail.
2 1 /
8
"
(55mm)
1"
(26mm)
1 3 / 16 "
(30mm)
1 5 /
16
"
(33mm)
6"
(152mm)
1"
(26mm)
Cat 5 or better shielded twisted pair (STP) cable
Shielded
RJ-45
connector
Shielded
RJ-45
connector
568-B Wiring Specification
Pair #
1
2
3
4
Wire
Orange/Wht
Orange
Green/Wht
Green
Blue
Blue/Wht
Brown/Wht
Brown
Pin #
1
2
3
6
4
5
7
8
Configuration
R Video (+)
R Video (-)
Horizontal Sync
Vertical Sync
G Video (+)
G Video (-)
B Video (+)
B Video (-)
Pair #
1
2
3
4
Wire
Orange/Wht
Orange
Green/Wht
Green
Blue
Blue/Wht
Brown/Wht
Brown
Pin #
1
2
3
6
4
5
7
8
Configuration
R Video (+)
R Video (-)
Horizontal Sync
Vertical Sync
G Video (+)
G Video (-)
B Video (+)
B Video (-)
EVT-TBP-GCNQ EVT-RBP-GNCQ PC Monitor
8 7 6 5 4 3 2 1
Pr 2 Pr 3
Pr 4 Pr 1
C
Shielded
RJ-45
connector
S
h
ie
ld
ed
at
5
or
be
tte
r
Figure 1:
RJ-45 shielded pin
configuration
Figure 2: