Woodstock D4088 - Manual

COPYRIGHT © JULY, 2010 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in China #13043CR
Model D4088 Drill Press
Lathe Attachment
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: [email protected] • Web: www.shopfox.biz
Specifications
Tool Rest Length ............................................. 12"
Maximum Workpiece Length (if reversed) ............... 24"
Maximum Workpiece Diameter ..............................6"
Shank Diameter of Screw and Spur Center .............. 3 ⁄
8
"
Construction Material .....................................Steel
Shipping Weight .........................................3.5 lbs.
Introduction
The Model D4088 Drill Press Lathe Attachment allows
wooden workpieces to be turned on a drill press in the
same manner as a wood lathe. Items like small pickets,
legs, spindles, handles, dowels, and pins can be made.
Fits drill press tables with T-nut slots or with slotted
through holes as shown in Figure 1.
Inventory
Refer to the list and Figure 2 to inventory your package.
If you can't find an item on this list, check the mounting
locations or examine the packaging materials carefully.
Occasionally we pre-install certain components for
shipping purposes.
If any nonproprietary parts are missing (e.g. a nut or a
washer), we will gladly replace them; or for the sake of
expediency, replacements can be obtained at your local
hardware store.
Description .................................................. Qty
A. Tool Rest ....................................................1
B. Screw Center ...............................................1
C. Spur Center .................................................1
D. Hex Wrenches 5, 6mm ................................1 Ea
E. Cap Screw M6-1 x 20 ......................................1
F. Tool Rest Foot ..............................................1
G. Carriage Bolt M10-1.5 x 40 ...............................2
H. Cap Screw M8-1.25 x 20 ..................................1
I. Base and Live Center Assembly .........................1
J. Flat Washer 10mm.........................................2
K. Hex Nut M10-1.5 ...........................................2
Figure 1. D4088 Drill Press Lathe
Attachment
Figure 2. Inventory.
A
C
B
E
F
D
G
H
I
J
K