Sony VPL-CS2 User Manual

Page 34

Advertising
background image

GB

34

Troubleshooting

VPL-CS2/CX1

4-079-834-11 (1)

D:\Data\Oka\407983411VPLCS2CX1WW\02GB-
VPLCS2,CX1WW\07MNT.fm

masterpage:Left

Sound

Remote Commander

On-screen display does not
appear.

• STATUS in the SET SETTING menu has been set to OFF.

c Set STATUS in the SET SETTING menu to ON (see page 30).

Color balance is incorrect.

• Picture has not been adjusted properly.

c Adjust the picture (see page 27).

• Projector is set to wrong color system.

c Set COLOR SYS in the PICTURE CTRL menu to match the

color system being input (see page 27).

The picture is too dark.

• Contrast or brightness has not been adjusted properly.

c Adjust the contrast or brightness in the PICTURE CTRL menu

properly (see page 27).

The picture is not clear.

• Picture is out of focus.

c Adjust the focus (see page 23).

• Condensation has occurred on the lens.

c Leave the projector for about two hours with the power on.

The picture appears too
small on the screen.

• SHIFT in the INPUT SETTING menu has not been adjusted

properly.
c Adjust SHIFT in the INPUT SETTING menu properly (see

page 28).

The picture flickers.

• DOT PHASE in the INPUT SETTING menu has not been adjusted

properly.
c Adjust DOT PHASE in the INPUT SETTING menu properly

(see page 28).

Symptom

Cause and Remedy

No sound.

• Cable is disconnected or the connections are wrong.

c Check that the proper connections have been made (see page

16).

When sound is input
through AUDIO connector,
sound comes through one
channel only.

• Monaural sound is being input through the AUDIO connector.

c Input stereo sound.

Symptom

Cause and Remedy

The Remote Commander
does not work.

• The Remote Commander batteries are dead.

c Replace with new batteries (see page 14).

• The front/rear remote control detector is near the fluorescent lamp.

c Change the setting of SIRCS RECEIVER in the SET SETTING

menu (see page 30).

The joystick, R CLICK, or
L CLICK key does not
function.

• The mouse port on the computer does not recognize the mouse

cable.
c Restart the computer.

Symptom

Cause and Remedy

Advertising
This manual is related to the following products: