Samson UHF 801 - Manual (Page 8)

8
Guided Tour - UT1L / UT1G
8: Power on-off switch* - Use this to turn the UT1L / UT1G on or off (to conserve battery
power, be sure to leave it off when not in use).
9: Audio Input Level control (trimpot) - This input sensitivity control has been factory
preset to provide optimum level for the particular lavalier or headset model being used
(in the case of the UT1G, it is preset for optimum instrument level) and so we recommend
that this not be adjusted manually. If necessary, however, you can use the supplied plastic
screwdriver (see #10 below) to raise or lower the UT1L / UT1G input level. See the
“Setting Up and Using the Series One System” section on page 8 in this manual for more
information.
10: Plastic screwdriver - Specially designed for use in adjusting the UT1L / UT1G Audio
Input Level control (see #8 above) and/or UR1 Mute control (see #7 on page 3). See the
“Setting Up and Using the Series One System” section on page 8 in this manual for more
information.
* Be sure to mute the audio signal at your external mixer or amplifier before turning
transmitter power on or off, or an audible pop may result.
SAMSON
8
9
7
10
ENGLISH