Smeg STA4645U - Manual (Page 12)

Rev 0.0
11
USER INSTRUCTIONS EN
2.2.8 Switching off
At the end of the program, the dishwasher emits a short beep and the indica-
tor lights of the fourth and fi fth program (ref. pr. 4, pr. 5 fi g. 2-04) fl ash.
Turn off the appliance by opening the door and pressing the on/off button (ref.
1 fi g. 2-02).
pr. 4 pr. 5
2.3 Additional functions
2.3.1 Adjusting the water softener
N.B.: a different washing program from soak must be used to make
the following adjustment. .
Press and hold down the program delay button (ref. 7 fi g. 2-05) until the pre-
set value appears followed by a dot (normally 3.). Release the button and then
press it again and again until the required value is displayed, as indicated in the
table (see tab. 2-03).
The 6 possible adjustment levels will appear in this sequence:
3., 4., 5., 0., 1., 2..
When the required value appears on the display, release the button; after 5
seconds the appliance automatically reverts to the program delay and the
adjustment is set to the chosen value.
Fig. 2-04