Sharp MX-C400P - Manual (Page 11)

9
INSTALLATION REQUIREMENTS
The performance of the machine is affected by the ambient conditions of the
installation location. Do not install in the following locations:
Do not install the machine in
locations that are excessively
hot, cold, humid, or dry (near
heaters, humidifiers, air
conditioners, etc.)
The paper will become damp and
condensation may form inside the
machine, causing misfeeds and dirty
output.
☞
Ambient environment (page 16)
If the location has an ultrasonic humidifier,
use pure water in the humidifier. If tap
water is used, minerals and other
impurities will be emitted, causing
impurities to collect on the inside of the
machine and create dirty output.
Exercise care not to expose the paper exit
part of the machine to wind or exhaust air.
The output paper may be blown to the
floor.
Near a wall
Be sure to allow the required space
around the machine for servicing and
proper ventilation. (The machine should
be no closer than the distances indicated
below from walls.)
CAUTION:
Do not install the machine in
a location with poor air
circulation.
A small amount of ozone is created
inside the machine during printing. The
amount of ozone created is not sufficient
to be harmful; however, an unpleasant
odor may be noticed during large printing
runs, and thus the machine should be
installed in a room with a ventilation fan
or windows that provide sufficient air
circulation. (The odor may occasionally
cause headaches.)
* Install the machine so that people are
not directly exposed to exhaust from
the machine. If installed near a
window, ensure that the machine is not
exposed to direct sunlight.
17-23/32"
(45cm)
11-13/16"
(30cm)
11-13/16"
(30cm)
mxc400p_us_saf_01.fm 9 ページ ２００９年１０月５日 月曜日 午後８時１０分