Snapper 1694874 - Manual (Page 24)

22
Removal &
Normal Installation
Removal
1. Fully raise and support the snowthrower with wood
blocks.
2. Manual Lift Models: Release and remove the lift
assist spring and anchor (F, Figure 33).
3. Lower the snowthrower.
4. Remove the clevis pin and clip (E) from the remote
deflector control and disconnect the control from the
mounting bracket.
5. Disconnect the rotator motor plug (A).
6. Disconnect the rear of the lift rod (B) from the lift arm
extension. Remove the hair pin clip (C) from the front
of the lift rod. Remove the lift rod. Remove the lift
arm extension from the tractor (see Hitch Installation
Instructions).
7. Use the trunnion handle (C, Figure 34) to relieve belt
tension. Remove the belt from the snowthrower drive
pulley (A, Figure 35).
A
C
D
B
E
F
G
G
H
Figure 33. Removal
A. Rotator Motor Plug
B. Lift Rod
C. Hair Pin Clip
D. Hitch Pin & Clip
E. Clevis Pin & Clip
F. Assist Spring &
Anchor
G. Clevis Pin & Hair Pin
H. RH Lift Lever
Assembly