SMC Networks SMC TigerCard 10G - Manual (Page 45)

M
OUNTING
3-7
Installing an Optional SFP Transceiver into the Switch
Figure 3-5 Inserting an SFP Transceiver into a Slot
The SFP slots support the following optional SFP transceivers:
• 1000BASE-SX (SMCBGSLCX1)
• 1000BASE-LX (SMCBGLLCX1)
• 1000BASE-ZX (SMCBGZLCX1)
These switches support 1000BASE-SX and 1000BASE-LX, and
1000BASE-ZX SFP transceivers. To install an SFP transceiver, do the
following:
1. Consider network and cabling requirements to select an appropriate
SFP transceiver type.
2. Insert the transceiver with the optical connector facing outward and
the slot connector facing down. Note that SFP transceivers are keyed
so they can only be installed in one orientation.
3. Slide the SFP transceiver into the slot until it clicks into place.
Note: SFP transceivers are hot-swappable. The switch does not need to
be powered off before installing or removing a transceiver.
However, always first disconnect the network cable before
removing a transceiver.
Note: SFP transceivers are not provided in the switch package.
45
46
47
48
Stack
Master Stack L
ink
Pow er
RPU
Diag Module
Stack
ID
Console
46
47
48
Master
Select