Sharp DIGITAL LASER COPIER/PRINTER AR-153E User Manual
Page 17
15
3
Using the RSPF/SPF
The RSPF/SPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2"
to 8-1/2" x 14" and weighting from 14 lbs. to 23.9 lbs.
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the
RSPF/SPF. If the stream feeding mode has been enabled using user program No.4,
the RSPF/SPF (
) indicator will blink approximately 5 seconds after the last
original has been fed by the RSPF/SPF. While this indicator is blinking, any new
originals placed in the original feeder tray will be fed and copied automatically. If the
stream feeding mode has been disabled, the start (
) key must be pressed each
time the originals are set even immediately after completion of a copy run from the
RSPF/SPF. The default setting of the stream feeding mode is "ON". See "USER
PROGRAMS" (p.23).
• Before feeding originals in the original feeder tray, be sure to remove
any staples or paper clips from them.
• Before placing curled or wavy originals into the original feeder tray, be
sure to flatten them. If not, original misfeeds may result.
• The RSPF/SPF (
) indicator on the operation panel will light up. If
this indicator does not light up, the originals are not properly set or the
RSPF/SPF is not properly closed.
• Badly damaged originals may misfeed in the RSPF/SPF. It is
recommended that such originals be copied from the original table.
• Special originals such as transparency film should not be fed through
the RSPF/SPF, but should be placed directly on the original table.
• Image loss (max. 5/32") can occur at the leading and trailing edges of
the copies. Also image loss (max. 11/64" in total) can occur along the
other edges of the copies. It can be 15/64" (max.) at the trailing edge
of the second copy of two-sided copying.
• To stop continuous copying using the RSPF/SPF, press the clear
(
)
key.
• Copying using one-sided to one-sided mode (AR-157E):
Ensure that no indicator is lit among the original to copy indicators.
Original face up
EQR[HOࡍࠫ㧞㧜㧜㧞ᐕ㧢㧝㧜ᣣޓᦐᣣޓඦ೨㧝㧝ᤨ㧡㧟ಽ