Smeg CB61VES - Manual (Page 28)

Instructions for the User
30
11.2.2 The pan stands
Remove the pan stands and wash them in warm water with a non-abrasive detergent, taking care to
remove all deposits. Put them back on the hob.
The continuous contact between the pan stands and the flame may cause deterioration in the
enamel in the areas exposed to heat over time. This is an absolutely natural phenomenon which
does not impair this component's operation at all.
11.2.3 The burner caps and flame diffuser rings
The burner caps and flame diffuser rings can be removed for easier
cleaning; wash them in hot water and non-abrasive detergent, taking
care to remove all deposits, and wait for them to dry completely.
WARNING: never wash these components in the dishwasher.
They may be left to soak in hot water and detergent.
Replace the flame diffuser rings, checking that they are correctly in place
with their respective burner caps, making sure that the holes A in the
flame diffusers are aligned with the plugs and thermocouples.
11.2.4 The plugs and thermocouples
For best performance, on the relevant models the ignition plugs and
thermocouples must always be kept thoroughly clean. Check them frequently
and if necessary clean them with a wet cloth. Remove any dry residues with a
wooden toothpick or a needle.
11.3 Cleaning the oven
To keep the oven in good condition, it must be cleaned regularly, after allowing it to cool down.
Remove all removable parts.
Clean the oven shelves with hot water and non-abrasive detergents, rinse and dry.
11.4 Door glazing
The glass in the door should always be kept thoroughly clean. Use absorbent kitchen roll; remove
stubborn dirt with a damp sponge and ordinary detergent.