Stow Plaster and Mortar Mixer (Gasoline Engine/Electric Motor) MS-93 - Manual (Page 13)

STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10) — PAGE 13
STOW MS-93 PLASTER/MORTAR MIXER — SAFETY CHAIN CONNECTION
Reference Figure 2 for the installation of the safety chain.
Tow Bar to Mixer Connection
1. Insert the tow bar through the round opening at the
bottom of the mixer stand.
Align the hole on the tow bar with the hole on the mixer
frame, and insert 1/2-inch bolt through tow bar and frame.
Secure tow bar to frame with 1/2-inch nylock nut. Tighten
to 40 ft.-lbs.
2. Route the safety chain through the holes just above the
tow bar, located on each side of the mixer stand.
Loop the chain together and place under the tow bar.
Secure the loop with the connector link.
3. extend the safety chain along the length of the tow bar,
looping it through the tow bar's connector link. Remove
any excess chain slack.
4. Connect the free end of (clevis safety hook) the safety
chain to the towing vehicle. Remember it is critical that
the length of the chain be properly adjusted, to prevent
the draw bar and the front of the mixer stand from
dropping to the the ground (contact) in the event the
draw bar becomes disconnected from the towing vehicle.
Figure 2. Tow Bar and Safety Chain Installation
Figure 3. Drum Latch Pin
(Tow or Locked Position)
NEVER! tow the mixer with the safety chain removed. The
safety chain is intended to prevent complete separation
of the mixer from the towing vehicle in the event of a tow
bar failure.
CAUTION
DO NOT tow the mixer unless the mixing drum is com-
pletely empty. AlWAyS make sure the drum latch pin
is fully engaged to the right (Figure 3) of the drum stop
block. This will keep the drum from rotating.
CAUTION
Always Tow with
a Safety Chain
Drum Saftey
when Towing