Spin Master Air Hogs Skywinder - Manual

BATTERY INSTALLATION
CONTROLLER CHARGER/TRAINER/
DISPLAY STAND
IMPORTANT BATTERY INFORMATION
• Battery installation should be performed by an adult.
• Use only batteries recommended. Be careful to install the batteries with the
correct polarity, as indicated.
• Do NOT mix old and new batteries.
• Do NOT mix alkaline, standard, or rechargeable batteries.
• Do NOT attempt to charge non-rechargeable batteries.
• Do NOT short circuit the supply terminals.
• Do NOT overcharge the plane’s batteries.
• Exhausted batteries are to be removed, as they will adversely affect the
performance.
• Do not dispose of batteries in fire. Battery may explode or leak.
• CAUTION: Plane contains a rechargeable cell. If fluid leaks from the plane,
avoid contact with eyes and dispose of the plane. Only use charger supplied
with this package.
• Do NOT use any other source to charge your SkyWinder TM .
• Different types of batteries or new and used batteries are not to be mixed.
• Do not use rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision
(if removable).
Contents:
1 SkyWinder™ Stunt Plane
1 Controller
1 Charger/Trainer/Display Stand
2 Extra Propellers
1 Tool
SKYWINDER™ STUNT PLANE
Antenna
Stunt Flap
Stunt Flap
Adjustment
Knob
Rudder
Horizontal
Tail
Wing
Main
Wing
Plane
Body
Propeller
ON/OFF
Switch
Charging
Port
Propeller
1. Use a Phillips screwdriver
to loosen the screw in the
battery compartment door.
2. Remove the battery door.
3. Insert six 1.5 Volt AA
batteries (not included).
4. Replace battery
compartment door and
refasten the screw.
IMPORTANT:
Be sure to insert the
batteries as indicated
inside compartment with
the correct polarity.
1. Use a Phillips screwdriver
to loosen the screw in the
battery compartment door.
2. Remove the battery door.
3. Insert eight 1.5 Volt D
alkaline batteries
(not included).
4. Replace battery
compartment door and
refasten the screw.
IMPORTANT:
Be sure to insert the
batteries as indicated inside
compartment with the
correct polarity.
INSTRUCTIONS
TM
NO ASSEMBLY
REQUIRED
Propeller
Tip
Propeller
Tip
CHARGER/TRAINER/DISPLAY STAND
CONTROLLER
Toggle
Charging
Indicator
Light
ON/OFF
Switch
Land
Button
Thrust
Button
Charger
Base
Charging
Hose
Charge
Nozzle
Training
Stand
Ready
Light
Charging
Light
ON/OFF
Switch
Tool
Vertical
Tail Wing
TM