Sony STRDG510 - Manual (Page 56)

56 GB
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 55).
3
Press AMP MENU.
“1-LEVEL” appears on the display.
4
Press V/v repeatedly to select
“4-TUNER”.
5
Press or b to enter the
menu.
6
Press V/v repeatedly to select
“NAME IN”.
7
Press or b to enter the
parameter.
The cursor flashes and you can select a
character. Follow the procedure given in
“To create an index name” below.
To create an index name
1 Use V/v/B/b to create an index name.
Press V/v to select a character, then press
B/b to move the cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select the
correct character.
Tip
You can select the character type as follows by
pressing
V/v.
Alphabet (upper case) t Numbers t Symbols
2 Press .
The entered name is registered.
Note (Models of area code CEL, CEK
only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
Naming preset stations
1 2 3
4 6
7 8
0/10 ENTER
9
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D.
RETURN/EXIT MENU
MOVIE MUSIC
MEMORY DVD MENU
CLEAR
TOOLS DISPLAY MUTING
TV VOL
MASTER VOL
FM MODE
D.TUNING
D.SKIP
AMP MENU
SAT TV SA-CD/CD TUNER
-
F
G g
f
5
>10/
1
3
4-7