Tuner, Control for hdmi – Sony STR-DH510 User Manual

Page 73

Advertising
background image

73

GB

Ad
ditional Inf

o

rmation

Recording cannot be carried out.

• Check that the components are connected

correctly.

• Select the source component using the

input buttons (page 35).

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 40).

• Press DISPLAY repeatedly so that the

frequency appears on the display.

RDS does not work.*

• Make sure that you are tuned to an FM

RDS station.

• Select a stronger FM station.

The RDS information that you want
does not appear.*

• Contact the radio station and find out

whether they actually provide the service
in question. If so, the service may be
temporarily out of order.

* Models of area code ECE, CEK, AU1 only.

The Control for HDMI function does not
work.

• Check the HDMI connection (page 23).
• Make sure “CTRL.HDMI” is set to

“CTRL ON” in the HDMI menu (page
58).

• Make sure the connected component is

compatible with the Control for HDMI
function.

• Check the Control for HDMI settings on

the connected component. Refer to the
operating instructions of the connected
component.

• Repeat the procedures of “Preparing for

the “BRAVIA” Sync” if you change the
HDMI connection, connect/disconnect the
AC power cord (mains lead), or when
there is a power failure (page 47).

Tuner

AM

ANTENNA

Receiver

To ground

Ground (earth)
wire (not supplied)

Outdoor FM antenna (aerial)

Control for HDMI

continued

Advertising
This manual is related to the following products: