Smeg American Style Fridge Freezer FA550X - Manual (Page 33)

25
LEVELLING YOUR REFRIGERATOR
The refrigerator has two front and two rear wheels at the
base of the product on each side that can be adjusted.
If the appliance seems unsteady or you want the doors to
close easier, adjust the appliance’s tilt following the
instructions below.
1. Check the installation location to be sure you have at least
1 cm clearance on all sides including the top.
2. Connect the appliance to the mains power supply.
3. Move the refrigerator into its final position.
4. Open both doors and remove the plinth to locate the
levelling bolts at the left and right of the refrigerator base.
The top bolt (1) will adjust the rear wheel, and the bottom
bolt (2) will adjust the front wheel.
5. Use the wrench provided to adjust the levelling bolts. Turn
the levelling bolt clockwise to raise the appliance, or anti-
clockwise to lower it.
It may take several turns of the levelling bolts to adjust the
tilt of the refrigerator.
Note: do not unscrew the levelling bolts too much when
lowering the appliance as they could fall out.
Aligning the doors
If, after switching on the appliance and adjusting the refrigerator
and freezer doors, the doors are misaligned, disconnect the
appliance from the power supply and adjust both doors as
indicated in the enclosed diagram.
6gb33032.fm5 Page 25 Monday, May 23, 2005 2:17 PM