Star Micronics FUTUREPRINT TSP100 - Manual (Page 13)

– 10 –
3-4. Connecting the USB Cable to the PC
Connect the USB interface cable to a USB
port of your PC.
Note: The dialog shown below may appear
on your PC screen if your PC is run-
ning Windows 98 or Me, and if you
turn ON the power of the printer for the
first time while the PC and the printer
are connected with the USB cable. In
this case, refer to the software manual
on the CD-ROM, in the following di-
rectory: Documents folder.
3-5. Installing the Printer Software
Here is the procedure for installing the printer driver and utility software, which
are stored on the supplied CD-ROM.
The procedure applies to the Windows operating systems shown below. For
instructions on the Linux and Macintosh OS X, refer to the software manual
located in the “Linux” and “Mac” folders on the CD-ROM.
· Windows 98 SE · Windows 2000
· Windows Me
· Windows XP
(1) Turn ON the power to your PC to start
Windows.
(2) Insert the supplied CD-ROM (Drivers and
Utilities) into the CD-ROM drive.
(3) Follow the instructions that appear on the
screen.
(4) The dialog shown in the illustration indi-
cates that the procedure has been com-
pleted. Click “OK”.
The dialog that appears on the screen varies with your system. This completes the
installation of the printer software. A message will appear, prompting you to
restart. Restart Windows.