Shakespeare Electronic 484 - Manual

Style 484
Thank you for purchasing a Shakespeare antenna product.
Customer comments are welcome. Before installing, please study
the diagram and check parts supplied against those listed.
IMPORTANT! Please read all instructions before installing.
The Style 484 Wall Mounting Bracket is a simple device for
mounting antennas and masts to a vertical or horizontal surface.
Tools required: Drill, drill bit, pliers or wrench,
screwdriver
Other materials required: Stainless steel mounting
hardware that is appropriate to the mounting surface
Installation Instructions
Choose a mounting location that is as high as possible, as free as
possible of obstructions, and as far as possible from other antennas.
1. Assemble the four clamp halves to the antenna’s mounting sleeve,
or to the mast you are mounting. Position one clamp at the bottom
of the mounting sleeve and the other clamp at the top of the
sleeve. The clamps should be at least one foot apart.
2. Hold the antenna against the mounting surface and mark the
location of the mounting holes, using the clamps as a template.
3. Drill holes according to the size of the mounting screws or bolts
(not supplied) to be used. Be sure to use only stainless steel
hardware. When drilling fiberglass, use wood boring bits, not
metal drilling bits, and use a backup wooden block underneath the
surface to reduce push-through damage.
4. Disassemble the clamps from the antenna and securely fasten the
clamp halves to the mounting surface.
Important: If the thickness of the mounting surface is not
adequate to support the strain, use a wooden or metal backup pad
(not supplied) underneath the surface during installation.
5. Reposition the antenna mounting sleeve in the clamps and tighten
securely. The clamp halves must remain a minimum of 1/4” apart
when the installation is complete.
35-90-0133-00
Supplied Parts
4 Clamp halves
4 Bolts
4 Nuts
4 Lockwashers
©1994, 2007 Shakespeare Co. · Form I-484 J: rev. 08/04/2012
Clamp
Lockwasher
Nut
Bolt
1/4” min, each clamp
Antenna mast
Clearance for 1/2” dia. bolt
or screw (not supplied)
Antenna mast
Mounting
surface
Clamp
Mounting screw
(not supplied)
Shakespeare Electronic Products Group
U.S. Operations: 6111 Shakespeare Rd. · Columbia, SC 29223 · 803-227-1590 · Fax: 803-419-3099 · www.shakespeare-marine.com
U.K. Operations: Enterprise Way, Fleetwood, Lancashire, FY7 8RY, England · +44 (0) 1253 858787 · Fax: +44 (0) 1253-859595 · www.vtronix-antennas.com
Shakespeare Co., LLC is a subsidiary of Jarden Corporation (NYSE: JAH)