StarTech.com PCI2S650PW - Manual (Page 6)

Instruction Manual
3
Failure to observe these warnings could cause damage to
the serial card, computer, and peripherals.
Do not set the jumpers J4 and J5 to supply
both 5v and 12v power at the same time.
Ensure jumper caps are placed vertically in line
with the markings on the board, not “across”
settings.
The card uses jumpers to set
internal and external power
voltages, and to configure
which serial ports will receive
5v, 12v, or RI signal
(unpowered) through the 9th
pin.
J2: Sets internal (bus) voltage
and the external power drawn
through the SP4 power
connector (external)
J4 and J5: Sets voltage for
each individual DB9 port
12VP 12V
A
5 VP 5 V
A
12VP 12V
A
5 VP 5 V
A
12VP 12V
A
5 VP 5 V
A
12VP 12V
A
5 VP 5 V
A
J2 J2 J2 J2
*Please select 5V, 12V, or RI Signal for COM1and COM2 using J4 and J5
Power
Supply
Int5V
Int12V
Int5V
Ext12
Ext5V
Int12V
Ext5V
Ext12V
Jumper Setting
J4 and J5
Jumper Setting
+12W +5V RI +12W +5V RI +12W +5V RI
5V 12V RI
Configuring the Jumpers: PCI2S650PW